COMPANY HEADER
Request Information
The series 119-1 (1.9 inch diameter) permanent magnet step motor is available in 7.5 degree or 15 degree step angles, and can be wound for bipolar or unipolar drives. Motors that are wound for bipolar drives can be run from an AC voltage source, using a capacitor to create a phase shift in the line voltage. This method creates a simple, low cost, reversing drive. Hansen motors can be custom wound for any voltage up to 240 V. The series 119 stepper is also available attached to a Hansen pear shaped gearbox, with virtually an unlimited number of gear ratios to choose from.
Unit of Measure

Specifications

Direct Current (DC) Voltage

 N/A 12 V

Voltage Type

 N/A DC

Drive Type

 N/A Bipolar

Step Angle

 N/A 15 º

Holding Torque

 N/A 7.2 in·oz

Detent Torque

 N/A 0.67 in·oz

Step Time

 N/A 6.2 ms

Rotor Inertia

 N/A 0.144 moiss

Resistance Per Phase

 N/A 45.5 Ohms

Inductance Per Phase

 N/A 129.8 mH

Voltage Constant

 N/A 31.6 V/krpm

Pull Out Torque versus Rate

 N/A 4.9 - (0.013*PPS) in·oz/PPS

Pull In Torque versus Rate

 N/A 4.9 - (0.014*PPS) in·oz/PPS

Wattage/Driver Type

 N/A Bipolar Centertap Unipolar

Motor Speed/Step Angle

 N/A 7.5 º15 º

Direct Current (DC) Rated Voltage

 N/A 5 V12 V24 V

Motor Type

 N/A Motor Only

Typical Applications

 N/A ATM Machine Beverage Dispensing HVAC Control Instrument Controls Lighting Controls Medical Devices POP Displays Robotic Controls Sun Tracker Video Games/Gaming Machine Voting Machine

Standard Features

Standard Features

 N/A
  • Rigid construction
  • Motor and output sleeve bearings
  • Variable lead positioning
  • 130 ºC insulation
  • Step angle accuracy range between ±5º and ±1.0º
  • Available with 50 Hz windings

Optional Features

Optional Features

 N/A
  • Voltages up to 240 V
  • Custom leads and terminations
  • Custom stepper motor outputs
  • Custom mounting
  • Custom shafting
  • Rear shaft extensions
  • Available with integrated driver/ controller